Xfinity cable stuck on welcome screen.

Video Display. To access Device Settings: Press the xfinity button on your remote. Use the left arrow or right arrow button to highlight Settings (the gear icon). Press OK. Note: If your remote doesn't have an OK button, press the raised button in the center of the directional pad. Use the down arrow button to highlight Device Settings. Press OK.To send a Private message to Xfinity Support from any Forum page: Click "Sign In" if that prompt is visible. • Click the "Direct Messaging" icon. • Click the "New message" (pencil and paper) icon. • Type "Xfinity Support" in the "To:" line and select "Xfinity Support" from the drop-down list which appears.The boxes have been rebooted probably 20 times. Each time, the Welcome screen appears, I answer No to Voice Guidance, then audio and video setting are optimized. I get to select a name for the box, and then, BAM, the Voice Guidance question is back. Regardless of the answer, the screen comes back again and again.To send a Private message to Xfinity Support from any Forum page: Click "Sign In" if that prompt is visible. • Click the "Direct Messaging" icon. • Click the "New message" (pencil and paper) icon. • Type "Xfinity Support" in the "To:" line and select "Xfinity Support" from the drop-down list which appears.1. Locate the reset button on the cable box. It is usually a small reset button near the power cable, the power button, or on the back of the box. 2. Press and hold the reset button for 10-15 seconds. This will reset the cable box and should bring it back to the default settings. 3.

This feature is turned on by default on your Xfinity TV Box. You can turn it off by going to Settings > Device Settings > Power Preferences > HDMI Device ...Hello, For over a week now our Xfininity X1 box has been stuck at ,"Welcome Powering Up. This may take a few minutes...". I've unplugged and plugged the system back in a few times. I've tried calling but never get through because everyone is working remote now. The phone message says that there is an outage in my area and they are working on it ...Jun 24, 2023 · Before going to bed I tested it and it was working. Next day it wasn’t working again, stuck on the reboot “Welcome” screen (restarting the box didn’t help). I chatted again with the Xfinity Assistant, who did something and fixed it. It’s been working for over a day now, including over night.

Here’s how you can reset your TV: Locate the power button on your TV or the remote control. Press and hold the power button for at least 10 seconds. Release the power button and wait for the TV to turn off and then back on. Once the TV restarts, check if the “Welcome” message is displayed correctly.Pick your device. Pick troubleshoot and then click on continue. The screen will load and you can click on “system refresh” to start the reset. There is also a default restore option if you don’t have the app. To use that, turn on the streaming device using the power button. Make sure the light is blinking green .

If you're connected properly, manually restarting your modem will often restore internet connectivity — the easiest way to do this is by unplugging your cable ...Hi I need advice or help on this situation I have in my X1 cable box still having issues with no signal cableXfinity Community Forum. TV. X1. ... Cable box frozen on welcome screen. I woke up this morning to my cable box stuck on the welcome screen (what it looks like when it updates every morning.) It will not move past that. I've unplugged and reconnected all of the plugs/cables multiple times, and I've tried to refresh/reset the box …Stuck at “Pairing your set-tip box with Wireless gateway”. Box was working fine. Now it stays at the “Let’s start by pairing your set-top box with your wireless gateway.”. Screen. - Have my own modem. - Remote will not work to select the 2 options of “initiate pairing” and “Manual Setup”. Like I said the box was working fine ...

How do I fix my Xfinity welcome screen? To fix Xfinity stuck on the welcome screen, check if your connections are tight and right. Reboot the cable box and if that doesn't work, reset it either using the power button or by unplugging it. Restarting the gateway could also fix the issue. If you have a Flex device, connect it using the WPS button.

Jun 6, 2020 · Stuck on welcome screen. We had to unplug our TV and flex box for a few minutes, and when we plugged them in again, we got stuck on the welcome screen. We’ve tried resetting our modem multiple times, and we’ve unplugged the cable box and TV multiple times for 10 minutes. Nothing works. Our internet is fine but we can’t get the TV past the ...

Click the "Peer to peer chat" icon. Click the "New message" (pencil and paper) icon. Type "Xfinity Support" in the "To:" line and select "Xfinity Support" from the drop-down list which appears. The "Xfinity Support" graphic replaces the "To:" line. Type your message in the text area near the bottom of the window.If your X1 or Xfinity Flex streaming TV Box is frozen on the Welcome screen, check your connections and attempt to restart it. If you have a wireless TV box or Xfinity Flex device, you can also try restarting your modem/gateway and try connecting using the WPS buttons on the TV Box or Flex device.The boxes have been rebooted probably 20 times. Each time, the Welcome screen appears, I answer No to Voice Guidance, then audio and video setting are optimized. I get to select a name for the box, and then, BAM, the Voice Guidance question is back. Regardless of the answer, the screen comes back again and again. Activation process. Enter the last four digits of any phone number listed on your Xfinity account. Use the number keys or directional pad on your remote to enter numbers. If you’re having trouble using the last four digits of a phone number, you can select the Verify another way button to verify via text message or by entering your account ... The Xfinity Flex box getting stuck on the welcome screen can be caused by several issues. Here are some of the common reasons why this might happen: 1. …If you have a Comcast account, odds are good that you get one or more services through Xfinity, a Comcast subsidiary that provides Wi-Fi, cable and digital TV packages, mobile serv...In some areas, the cable boxes are configured with a startup channel. Both SA and Motorola can be configured to do it. Often, there is no way ...

Cable stuck on welcome screen. Closed. My cable box is stuck on the welcome screen. I’ve unplugged it numerous time, once for 3 hours, and nothing works. Archived post. …screen and if I choose yes or no, regardless which choice" the Voice Guidance screen comes back up. I checked the cable connection, connection to the TV, the usual stuff and that didn't help. I power cycled the cable box and that didn't help. I called phone support and the agent did a system refresh, which didn't help.If your Xfinity Flex has software issues, a loose cable, or is not connected properly to the WiFi network, it can be stuck on the welcome screen when you turn it on. To fix this, check the connection of your Xfinity Flex to the router. Ensure that the ethernet cable is connected all the way and that it is in range of the WiFi network.ngk marine spark plug chart split brain experiments game. what happened rodd elizondo. About Us. mill creek high school; what weirdly specific trope are you quizIt froze the other night, so we unplugged it to restart it. Now, when I plug it back into the power, the blue light blinks, then turns off. The scroll on my screen says “Welcome., etc”. use a light and see what the name of the connector (coax) is that the cable is attached to. you may have the coax on the wrong coax connector.

Comcast cable bills can be paid by sending a check with the bill you receive, by paying online through Comcast’s website, by using a mobile device, or they can be paid in person. C...

is the flex box an Xi5 or Xi6 wireless? you can connect via ethernet if so to the gateway/modem. I'm trying to set up my Flex box and it's stuck on the screen that says "Welcome. Bienvenido. Bienvenue." I currently provide my own modem/router--is this the issue?Stuck on the welcome screen with 4k box. Official Reply. Got the new box, fired it up and I get the welcome screen. "Welcome. Bienvenido. Bienvenue." Same coax, nice and tight. New hdmi cable (not that it makes much difference). Two restarts, no difference.Yes, cables attached to both ends of the TV and device can cause xfinity screen jam. You can be able to slow down the sight of a greeting message for hours. To fix this, take all cables out of the device and tv. Now insert the cables into the TV box and open the power. After a few minutes, connect the cables to the TV.I woke up this morning to my cable box stuck on the welcome screen (what it looks like when it updates every morning.) It will not move past that. I've unplugged and reconnected all of the plugs/cables multiple times, and I've tried to refresh/reset the box via the website.Find the Reset button on your Flex TV box. Press and hold it for about 10 seconds until the LED starts blinking. Release the button and allow the box to reset. To Soft Reset: Verify that the device is turned on and operational. Simultaneously press and hold the ‘ ‘POWER’ ‘ and ‘ ‘MENU’ ‘ buttons on your remote control.This is the procedure I used. Press the settings button until the light turns green. Then press the AB button for five seconds. For some reason, I didn't need to press/ enter 981 following the pressing of the AB buttons. It just started working.

Cable stuck on welcome screen. My cable box is stuck on the welcome screen. I’ve unplugged it numerous time, once for 3 hours, and nothing works. Archived post. New comments cannot be posted and votes cannot be cast. Hello u/BabaComm1981, thanks for reaching out for help on Reddit!

Jun 6, 2020 · Stuck on welcome screen. We had to unplug our TV and flex box for a few minutes, and when we plugged them in again, we got stuck on the welcome screen. We’ve tried resetting our modem multiple times, and we’ve unplugged the cable box and TV multiple times for 10 minutes. Nothing works. Our internet is fine but we can’t get the TV past the ...

Member. 2023-Dec-8 7:45 pm. More nightmare. XG1v4 stuck in Welcome boot loop. Got a network switch today to hardwire new xi6 box. Set it up, hardwired xi6, xpod, and verizon network extender ...Aug 29, 2022 · This seemingly doesn’t show that the cable is damaged, but inside the core of the cable is torn and lost its temper. Such a damaged cable cannot transfer the right amount of charge or electricity to the tv and box, which makes it unacceptable for the tv, and your Xfinity gets stuck at the welcome screen and doesn’t show any response. To send a Private message to Xfinity Support from any Forum page: Click "Sign In" if that prompt is visible. • Click the "Direct Messaging" icon. • Click the "New message" (pencil and paper) icon. • Type "Xfinity Support" in the "To:" line and select "Xfinity Support" from the drop-down list which appears.Connection problems can also contribute to the Xfinity box getting stuck on the welcome screen. Issues with the HDMI cable, for example, can prevent the box from establishing a proper connection with the TV, resulting in the welcome screen freeze. Similarly, problems with the internet connection, such as slow or unstable connectivity, …I woke up this morning to my cable box stuck on the welcome screen (what it looks like when it updates every morning.) It will not move past that. I've unplugged and reconnected all of the plugs/cables multiple times, and I've tried to refresh/reset the box via the website. Nothing changes.5 Messages. 3 years ago. @Rustyben wrote: @pewter_moose wrote: Had to exchange my old box for a new one today, but the new one gets stuck on the Welcome screen. I plugged everything in correctly, it powered up but rotates between the "Welcome. Powering up.1.3K Messages. Welcome to our community forum, @user_08ca1b! You've reached the perfect place to get help with any questions or concerns you have about your Xfinity service. Voice guidance is a life saver for some customers but it can definitely be a nuisance when you don't need it!X1 Activation Start-Up Screens While the Welcome screens are displayed, the TV Box is connecting to cloud services that include the activation applications. Back to Top Mandatory Firmware Download Screens X1 TV Boxes with older firmware versions may show the following message: "We’re updating your TV Box to the best experience possible," along …Stuck on welcome screen. We had to unplug our TV and flex box for a few minutes, and when we plugged them in again, we got stuck on the welcome screen. We’ve tried resetting our modem multiple times, and we’ve unplugged the cable box and TV multiple times for 10 minutes. Nothing works.I came home today around 4:00 PM and turned my tv on. The display showed the “Welcome. Bienvenido. Bienvenue.” boot screen. I waited a while and it never changed. I unplugged the power for 30 secon...My Xumo Streaming Box is Stuck on Settings Page : r/Comcast_Xfinity. Help! My Xumo Streaming Box is Stuck on Settings Page. I turned on my tv and this was there. You can’t get to the homepage or anything other than view the settings. I’ve tried unplugging and all of that but it’s just the settings page. I just got this streaming box a ...

Jan 6, 2024 · Cable box stuck on welcome.screen. Question • Updated. Xfinity and Apple TV+ apparently have a problem together that needs to be solved together. More reports are showing up on both Xfinity and Apple user forums. UPDATE 1 10/7/23 afternoon:: I DM'd with Xfinity support and, after going through a lot of Q&A, Xfinity support refreshed the signal to my X1 box and it has appeared to correct …Xfinity box frozen on welcome screen. Solved. I’ve never had this problem before in my 2 years, it’s stuck on the welcome screen and it was totally fine earlier in the day when I watched tv but when I turned it on it was stuck on the welcome screen. The wires were checked and all tightened and I restarted it by taking the power out.Instagram:https://instagram. diamonds international credit cardchase routing number in chicagolittle caesars duncan south carolinarainbow car wash brighton mi Comcast is one of the largest providers of cable TV and internet services in the United States. With a wide variety of packages and channels available, it can be difficult to know ... olive garden italian restaurant tallahassee menuis floyd boudreaux still alive Mar 19, 2024 · Perform a System Refresh. If the Xfinity welcome screen is stuck due to issues in the Xfinity box’s system settings, you can perform a System Refresh to resolve it. Here are the steps to System Refresh your Xfinity box. Open the Xfinity My Account App on your device. Go to the Overview Menu and locate the TV option. siren wi pet store Jun 6, 2020 · Stuck on welcome screen. We had to unplug our TV and flex box for a few minutes, and when we plugged them in again, we got stuck on the welcome screen. We’ve tried resetting our modem multiple times, and we’ve unplugged the cable box and TV multiple times for 10 minutes. Nothing works. Our internet is fine but we can’t get the TV past the ... I returned the box for a new one at the Xfinity store and it's working now. It had been a working for a few years but I turned the TV on one day and it was stuck on that screen. Despite getting a notice both in chat and on the phone that I would not be receiving a call back, I did get a call from an agent about 90 minutes later.